Leibinger JET3, Руководство по эксплуатации

Страница: 102 / 406

Page 100 Job Editor Group 8
Release 2.02 JET3 Series
Encoder Parameter (27)
<Encoder Source> (28) The encoder source can either be external (hardware
encoder) or internal (defining the speed).
<Resolution> (29) In this display field the resolution of the used encoder
has to be defined in pulses per millimeter.
<intern Speed> (30) There has to be an internal speed defined in case no
external encoder is used.
<Encoder/Direction> (31) For an external encoder it can be defined which
rotational directions shall be detected.
<Speed dependent
output> (32)
The digital outputs of the printers can be linked with
the measured speed. The assigned output switches
to high level once the set speed is reached
/exceeded. The assigned output switches back to low
level when the speed falls 10% below the set speed.
Please see chapter
8.5.3.5 Speed dependent output
for details.
<Sensor distance> (33) Distance parameter if the speed is measured by two
sensors instead of an encoder.
<use encoder direction for
mirror> (34) The directional information of the encoder can be used
to mirror the print out.
<lock backward> (35) With this option selected the backward movements of
an external encoder will be ignored.
Date Change Parameter (36)
<Date Change Offset> (37) There can be defined a date change offset with a
maximum of 23 hours and 59 minutes. The offset
can be defined as positive or negative offset. E.g.
with an offset of +3 the date would not change at
00:00 but at 03:00.