SDA Operator’s Manual
SMART Triggers
Width Trigger
How Width Trigger Works
Width trigger allows you to define a positive- or negative-going pulse width bounded by a voltage
level, above or below which a trigger will occur. You can specify a pulse width and voltage range,
within or outside of which a trigger will occur.
Width Trigger Setup
1. In the menu bar, touch
Trigger
, then
Trigger Setup...
in the drop-down menu.
2. Touch
the
Width
trigger button
3. Touch
inside
the
Trigger On
data entry field and select a source on which to trigger:
4. Touch
inside
the
Level
data entry field and enter a value using the pop-up numeric keypad.
5. Select positive or negative slope.
6. Touch
the
LessThan
button and enter a pulse-width value in the
Upper Limit
data entry
field. Or touch the
GreaterThan
button and enter a pulse-width value in the
Lower Limit
data
entry field. Or touch the
InRange
button. Touch the
Delta
button
to set up a nominal
range, plus or minus a delta value in seconds. Touch inside the
Nominal Width
and
Delta
data entry fields and enter values using the pop-up numeric keypads. Alternately, touch the
Limits
button
to set up a precise pulse-width range. Touch inside the
Lower Limit
and
Upper Limit
data entry fields and enter values using the pop-up keypads. Or touch the
OutOfRange
button and perform the same range setups as for InRange triggering.
SDA-OM-E Rev H
83
Содержание SDA
