Hawker Beechcraft Hawker 800XP, Руководство по эксплуатации для пилотов

Страница: 868 / 923

Hawker 800XP Pro Line 21
Section VI - GROUND OPERATIONS
Page 2-39
Sub-section 2
GROUND SERVICING
Pilot’s Operating Manual
Revision A2: Nov, 2004
On the overhead roof panel,
the following annunciators will illuminate.
Figure 12
Energizing DC Busbars
APU (if installed)
Running at Governed Speed
Switch the external power supply ON and wait at least
30 seconds to select the EXT POWER switch ON.
The busbar system is energized from the ground power supply.
The airplane and APU generator outputs are isolated.
Select the EXT BATT CHG switch ON.
Monitor busbar voltages PS1 - PE - PS2 on the
voltmeter using the selector switch. Operate AMPS
BATT push switch to check the battery charge. If less
than 40 AMPS, operate 0-40 push switch for accurate
ammeter reading.
PS1 BUSBAR
PS2 BUSBAR
BATT 1
Power
Diode
Monitor the battery voltage on B1, B2, and PE
by using the voltmeter selector switch.
ESSENTIAL DC BUSBAR - PE
Power
Diode
When the BATTERY switch is selected to EMERG,
No. 1 and No. 2 batteries are connected in parallel
to supply PE busbar.
When the EXT POWER switch is selected OFF
and the BATTERY switch is selected ON,
the No. 1 and No. 2 batteries will connect in
parallel to supply the PE busbar.
Check the APU MASTER, BATTERY, EXT POWER and external
ground supply switches are selected OFF.
Connect ground power supply to the airplane receptacle (Figure 13).
With the generator line contactor CLOSED
and the BUS TIE switch selected CLOSE,
PS1 and PS2 busbars will be linked.
If a ground power supply is connected and
switched ON with the APU generator output
isolated, the above annunciator will illuminate.
CNTCTR
BATT 2
CNTCTR
BUS TIE
OPEN
GEN 1
FAIL
GEN 2
FAIL
On the APU control panel,
check the following annunciator, is extinguished.
DC
Ground Supply
APU
GEN
No. 2
Battery
No. 1
Battery
PE2
APU
Generator