Hawker Beechcraft Hawker 800XP, Руководство по эксплуатации для пилотов, Страница: 339 / 923

Page 17-12
Section III Sub-section 17
AVIONICS
P/N 140-590032-0007
Revision A4: Sep, 2010
Pilot’s Operating Manual
ACP Operation
Control Function
SELCAL indicator lamps
A SELCAL lamp is located above each respective
transceiver and illuminates when a ground to air
SELCAL signal is received or SELCAL is tested.
TRANSCEIVER switches/volumes
VHF 1, VHF 2, HF 1, and HF 2 (if option installed)
receiver switch functions and volume controls.
The OUT position enables receiver audio.
MIC SELECT switch
6 or 12 position rotary switch (dependent on ACP
installation) Refer to Figure 5.
Selects transmission source.
RECEIVER switches/volumes
VOR/ILS 1 and 2, ADF 1, and ADF 2 (if option installed),
DME 1 and 2, MKR 1 and 2 receiver switch functions
and volume controls. The OUT position enables receiver
audio.
PA Volume
PA volume is only connected to the output at the ACP
when the Transmit Select Switch is in the PA position
and the Transmit PTT is pushed.
NORM/EMERG switch
When switched to EMERG, this feature is designed to
allow the operator to switch transmit and interphone
functions to the cross-side audio control panel. This
feature allows the operator to retain most of the
station’s normal function even in the event of failure of
that station.
NORM/VOICE/TONE switch
NORM position - Voice and Ident enabled.
VOICE position - Voice only enabled.
TONE position - Ident only enabled.
PHONE volume SPKR-PHONE
Headphone and loudspeaker volume control and SPKR
ON/OFF switching. The OUT position turns loudspeaker
ON.
I/C (Interphone) switch/volume
Interphone volume control. The IN position turns
microphone ON continuously.
AUTOCOM switch
When the AUTOCOM switch is in the AUTOCOM
position the channel selected by the rotary MIC
SELECT switch shall auto enable (automatically on)
even if the receiver function and volume control knob is
not enabled (out position). The receiver function and
volume control knob can still be used to adjust volume
for that channel selected by the MIC SELECT switch.
The receiver function and volume control knob will not
illuminate while disabled.