3
Flow of setup for data communication
The setup work needed to connect FOMA
terminal to a PC to perform packet or 64K data
communication is as follows:
Communication configuration file (driver)
Install the communication configuration file on a PC
from the attached CD-ROM before connecting FOMA
terminal to a PC to perform data communication.
FOMA PC configuration software
When the FOMA PC configuration software (found on
the CD-ROM) is installed on a PC, a number of
settings required for packet communication or 64K
data communication via connection between FOMA
terminal and PC can be made from the PC by simple
operation.
Before installation/uninstallation
・
Installing and uninstalling the communication
configuration file or the FOMA PC configuration
software can only be performed by a user with
administrator privileges. Attempts made by other
users will result in errors. For details on PC
administrator privileges, refer to the instruction
manual of the PC or contact your PC manufacturer
or Microsoft Corporation.
・
Before starting operation, make sure that no other
program is running. If there is any active program,
save and exit the program before operation.
Connecting PC to FOMA terminal
The connection should be made with the PC and
FOMA terminal both switched on.
・
Be sure to install the communication configuration
file (driver) before connection.
☛
P4
Connecting a PC
Connect by using the FOMA USB cable (optional).
a
Open the cap on the FOMA terminal’s
external connection terminal
b
Insert one end of the FOMA USB cable into
the FOMA terminal’s external connection
terminal until it clicks
c
Insert the other end of the FOMA USB cable into
the PC USB connector
・
When a PC and FOMA terminal are connected,
appears on the screen of FOMA terminal.
does not appear before installing the
communication configuration file.
・
If you connect FOMA terminal to a PC before
installing the communication configuration file,
the wizard screen indicating the detection of
new hardware will be displayed. In that case,
remove FOMA terminal and click
キャンセル
(Cancel) to exit the wizard.
Install the FOMA PC configuration software
☛
P6
(Easy Setup)
Packet communication
setup
●
mopera U / mopera
☛
P7
●
Other providers
☛
P9
(Easy Setup)
64K data communication
setup
●
mopera U / mopera
☛
P10
●
Other providers
☛
P11
Execute communication
☛
P12 (Disconnect
☛
P13)
Set up communications without using the FOMA PC
configuration software
☛
P16
Connect
☛
P23 (Disconnect
☛
P23)
Install the communication configuration file
☛
P4
Connect a PC to FOMA terminal
☛
P3
Check the communication configuration file
☛
P5
Setting to
Communication mode
In case USB Mode Setting is set to
microSD mode
or
MTP mode
, set this to
Communication mode
.
a
m626
z
1
Next
▲
D903i Manual for Data Commu.fm 3 ページ 2006年10月12日 木曜日 午後5時45分