Digi TX54, Руководство пользователя

Страница: 887 / 1087

System administration Power ignition sensor
TX54 User Guide 887
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. To set the ignition power on delay:
(config)> system power ignition on_delay value
where value is any number of hours, minutes, or seconds, and takes the format number
{ h|m|s }.
For example, to set the ignition power on delay to ten minutes, enter either 10m or 600s :
(config)> system power ignition on_delay 600s
(config)>
The default is 0s , meaning that there is no power on delay.
4. To set the ignition power off delay:
(config)> system power ignition off_delay value
where value is any number of hours, minutes, or seconds, and takes the format number
{ h|m|s }.
For example, to set the ignition power off delay to ten minutes, enter either 10m or 600s :
(config)> system power ignition off_delay 600s
(config)>
The default is 0s , meaning that there is no power off delay.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.