Digi TX54, Руководство пользователя

Страница: 304 / 1087

Hotspot Hotspot configuration
TX54 User Guide 304
/network/wifi/ap/digi_hotspot_ap2
(config)> add network bridge hotspot_bridge device end /network/
4. Add a new device. For example, to add the ETH4 device:
(config)> add network bridge hotspot_bridge device end
/network/device/eth4
(config)>
By default, the ETH1 device is configured as the device for the WAN1 interface, and ETH2 ,
ETH3 , and ETH4 are configured as devices in the LAN1 bridge, which is used by the LAN1
interface. As a result, when you add an Ethernet port to the hotspot, you may need to
reconfigure the Ethernet port configuration for other interfaces. For example, to remove the
ETH4 port from the LAN1 bridge:
a. Display the current LAN1 bridge configuration:
(config)> show network bridge lan1 device
0 /network/device/eth2
1 /network/device/eth3
2 /network/device/eth4
3 /network/wifi/ap/digi_ap1
4 /network/wifi/ap/digi_ap2
(config)>
b. Use the index number, 2 , to remove the ETH4 device from the LAN1 bridge:
(config)> del network bridge lan1 device 2
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Use policy routes with hotspot
When creating policy routes for hotspots, the source address should be set to use the hotspot zone:

WebUI
1. Create a new routing policy. See Configure a routing policy for instructions.
2. During configuration, for Source address :
a. For Type , select Zone .
b. For Zone , select hotspot .