Digi TX54, Руководство пользователя

Страница: 1022 / 1087

Command line interface Access the command line interface
TX54 User Guide 1022
Access the command line interface
You can access the TX54 command line interface using an SSH connection, a telnet connection, or a
serial connection. You can use an open-source terminal software, such as PuTTY or TeraTerm, to
access the device through one of these mechanisms.
You can also access the command line interface in the WebUI by using the Terminal , or the Digi
Remote Manager by using the Console .
To access the command line, your device must be configured to allow access, and you must log in as
a user who has been configured for the appropriate access. For further information about configuring
access to these services, see:
n
Serial: Serial port
n
WebUI: Configure the web administration service
n
SSH: Configure SSH access
n Telnet: Configure telnet access
Log in to the command line interface

Command line
1. Connect to the TX54 device by using a serial connection, SSH or telnet, or the Terminal in the
WebUI or the Console in the Digi Remote Manager. See Access the command line interface for
more information.
n
For serial connections, the default configuration is:
l
115200 baud rate
l
8 data bits
l
no parity
l
1 stop bit
l
no flow control
n For SSH and telnet connections, the default IP address of the device is 192.168.2.1 on
the ETH2, ETH3, and ETH4 Ethernet ports.
2. At the login prompt, enter the username and password of a user with Admin access:
login: admin
Password: **********
The default username is admin . The default unique password for your device is printed on the
device label.
3. Depending on the device configuration, you may be presented with another menu, for
example:
Access selection menu:
a: Admin CLI
s: Shell
q: Quit