Digi TX54, Руководство пользователя

Страница: 254 / 1087

Wi-Fi Configure a Wi-Fi access point with personal security
TX54 User Guide 254
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
1. Assign the Wi-Fi access point to a LAN interface or to a bridge. See Configure a LAN and
Configure a bridge for more information.
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Edit an existing Access point
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Show available access points:
(config)> network wifi ap ?
Additional Configuration
------------------------------------------------------------------------
-------
digi_ap1 Digi AP (Wi-Fi1)
digi_ap2 Digi AP (Wi-Fi2)
(config)>
4. Set the SSID for the appropriate access point:
(config)> network wifi ap digi_ap1 ssid my_SSID
(config)>
5. SSID broadcasting is enabled by default for the preconfigured access points. If SSID
broadcasting is disabled:
(config)> network wifi ap digi_ap1 ssid_broadcast true
(config)>