Digi TX54, Руководство пользователя

Страница: 34 / 1087

Hardware setup Connect data cables
TX54 User Guide 34
3. Once the surface is clean and dry, apply a small amount of dielectric grease in a thin layer over
the contacts. Use a new cotton-tipped applicator to work the grease smoothy over the
contacts. Apply gentle pressure.
4. When the dielectric grease has been applied, insert the SIM into the SIM slot as described
above.
Tips for improving cellular signal strength
If the signal strength LEDs or the signal quality for your device indicate Poor or No service , try the
following things to improve signal strength:
n
Move the device to another location.
n
Try connecting a different set of antennas, if available.
n
Purchase a Digi Antenna Extender Kit: Antenna Extender Kit, 1m .
Connect data cables
The TX54 provides two types of data ports:
n Ethernet (RJ-45): Use a Cat 5e or Cat 6 Ethernet cable.
n
Serial (9-pin RS-232): Use a serial cable with a 9-pin RS-232 connector.
Connect antennas
Connect antennas to the appropriate antenna connector:
n
Wi-Fi-1 and Wi-Fi-2 (Wi-Fi enabled models only).
n
WWAN-1 and WWAN-2.
Mount the TX54 to a mounting surface
Mount the TX54 device to a mounting surface by using the two mounting brackets. The mounting
brackets are preinstalled when the device is delivered.
Tighten self-tapping screws to the mounting surface through the mounting holes of mounting
brackets.
Note The mounting screw specifications are: Roundhead M4 size screws or comparable non-metric (6-
32 size). Type and length is dependent on the mounting surface type.