Digi TX54, Руководство пользователя

Страница: 269 / 1087

Wi-Fi Isolate Wi-Fi clients
TX54 User Guide 269
a. Click Configuration > Network > Interfaces .
b. For Add interface , type a name for the LAN and click

.
c. For Zone , select LAN2_isolation_zone .
d. For Device , select the new Wi-Fi access point or, for dual-Wi-Fi models, if you are using
both of the preconfigured access points rather than creating a new access point, select Wi-
Fi access point: Digi AP (Wi-Fi2) .
e. Click to expand IPv4 .
f. For Address , type an IP address and subnet for the LAN.
g. Click to expand DHCP server .
h. Enable the DHCP server.
6. Remove the Digi AP (Wi-Fi2) access point from the LAN1 bridge:
This step applies to dual-Wi-Fi models only, and only if you are using both preconfigured
access points, rather than creating a new access point.
a. Click Network > Bridges > LAN1 .
b. Click the down arrow (

) next to the the Digi AP (Wi-Fi2) access point and select Delete .
7. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.