Digi TX54, Руководство пользователя

Страница: 87 / 1087

Interfaces Wide Area Networks (WANs)
TX54 User Guide 87

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change to WAN or WWAN's node in the configuration schema. For example, to disable SureLink
for an interface named my_wan:
(config)> network interface my_wan
(config network interface my_wan)>
4. Determine the index number of the target:
(config network interface my_wan)> show ipv4 surelink target
0
interface_down_time 600s
interface_timeout 120s
test interface_up
1
test dns_configured
(config network interface my_wan)>
5. Delete the target:
(config network interface my_wan> del ipv4 surelink target 1
(config network interface my_wan)>
6. Save the configuration and apply the change:
(config network interface my_wan ipv4 surelink)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Example: Use a ping test for WAN failover from Ethernet to cellular
In this example configuration, the WAN1 interface serves as the primary WAN, while the cellular
WWAN1 and WWAN2 interfaces, respectively, serve as the backup WANs. This example assumes a
dual-cellular model.