Digi TX54, Руководство пользователя

Страница: 488 / 1087

Virtual Private Networks (VPN) Generic Routing Encapsulation (GRE)
TX54 User Guide 488
3. Click Network > Interfaces .
4. For Add Interface , type a name for the GRE loopback endpoint interface and click

.
5. Enable the interface.
New interfaces are enabled by default. To disable, or to enable if it has been disabled, click
Enable .
6. For Interface type , select Ethernet .
7. For Zone , select Internal .
8. For Device , select Ethernet: Loopback .
9. Click to expand IPv4 .
10. For Address , enter the IP address and subnet mask of the local GRE endpoint, for example
10.10.1.1/24 .
11. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add the GRE endpoint interface. For example, to add an interface named gre_endpoint :
(config)> add network interface gre_interface
(config network interface gre_interface)>