Digi TX54, Руководство пользователя

Страница: 672 / 1087

Applications Configure scripts to run automatically
TX54 User Guide 672

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a script:
(config)> add system schedule script end
(config system schedule script 0)>
Scheduled scripts are enabled by default. To disable:
(config system schedule script 0)> enable false
(config system schedule script 0)>
4. (Optional) Provide a label for the script.
(config system schedule script 0)> label value
(config system schedule script 0)>
where value is any string. if spaces are used, enclose value within double quotes.
5. Set the mode that will be used to run the script:
(config system schedule script 0)> when mode
(config system schedule script 0)>
where mode is one of the following:
n
boot : The script will run once each time the device boots.
l
If boot is selected, set the action that will be taken when the script completes:
(config system schedule script 0)> exit_action action
(config system schedule script 0)>
where action is one of the following:
o none : Action taken when the script exits.
o
restart : Runs the script repeatedly.
o reboot : The device will reboot when the script completes.
n
interval : The script will start running at the specified interval, within 30 seconds after
the configuration change is saved. If interval is selected: