Dell PowerConnect B-FCXs, Руководство по настройке

Страница: 979 / 1494

PowerConnect B-Series FCX Configuration Guide 937
53-1002266-01
Configuring OSPF
29
The <ip-mask> parameter specifies the portions of the IP address that a route must contain to be
summarized in the summary route. In the example above, all networks that begin with 209.157 are
summarized into a single route.
Assigning an area range (optional)
You can assign a range for an area, but it is not required. Ranges allow a specific IP address and
mask to represent a range of IP addresses within an area, so that only that reference range
address is advertised to the network, instead of all the addresses within that range. Each area can
have up to 32 range addresses.
Example
To define an area range for subnets on 193.45.5.1 and 193.45.6.2, enter the following commands.
PowerConnect(config)#router ospf
PowerConnect(config-ospf-router)#area 192.45.5.1 range 193.45.0.0 255.255.0.0
PowerConnect(config-ospf-router)#area 193.45.6.2 range 193.45.0.0 255.255.0.0
Syntax: area <num> | <ip-addr> range <ip-addr> <ip-mask>
The <num> | <ip-addr> parameter specifies the area number, which can be in IP address format.
The range <ip-addr> parameter specifies the IP address portion of the range. The software
compares the address with the significant bits in the mask. All network addresses that match this
comparison are summarized in a single route advertised by the router.
The <ip-mask> parameter specifies the portions of the IP address that a route must contain to be
summarized in the summary route. In the example above, all networks that begin with 193.45 are
summarized into a single route.
Assigning interfaces to an area
Once you define OSPF areas, you can assign interfaces to the areas. All router ports must be
assigned to one of the defined areas on an OSPF router. When a port is assigned to an area, all
corresponding subnets on that port are automatically included in the assignment.
To assign interface 1/8 to area 195.5.0.0 and then save the changes, enter the following
commands.
PowerConnect(config-ospf-router)#interface e 1/8
PowerConnect(config-if-1/8)#ip ospf area 195.5.0.0
PowerConnect(config-if-1/8)#write memory
Modifying interface defaults
OSPF has interface parameters that you can configure. For simplicity, each of these parameters
has a default value. No change to these default values is required except as needed for specific
network configurations.
Port default values can be modified using the following commands at the interface configuration
level of the CLI:
•
ip ospf area <ip-addr>
•
ip ospf auth-change-wait-time <secs>
•
ip ospf authentication-key [0 | 1] <string>