Dell PowerConnect B-FCXs, Руководство по настройке

Страница: 1161 / 1494

PowerConnect B-Series FCX Configuration Guide 1119
53-1002266-01
Configuring additional VRRP and VRRPE parameters
31
Syntax: track-port ethernet [ <slotnum>/ ] <portnum> | ve <num>
The syntax is the same for VRRP and VRRPE.
Track priority
When you configure a VRID to track the link state of other interfaces, if one of the tracked interface
goes down, the software changes the VRRP or VRRPE priority of the VRID interface:
•
For VRRP, the software changes the priority of the VRID to the track priority, which typically is
lower than the VRID priority and lower than the VRID priorities configured on the Backups. For
example, if the VRRPE interface priority is 100 and a tracked interface with track priority 60
goes down, the software changes the VRRPE interface priority to 60.
•
For VRRPE, the software reduces the VRID priority by the amount of the priority of the tracked
interface that went down. For example, if the VRRPE interface priority is 100 and a tracked
interface with track priority 60 goes down, the software changes the VRRPE interface priority to
40. If another tracked interface goes down, the software reduces the VRID priority again, by
the amount of the tracked interface track priority.
The default track priority for a VRRP Owner is 2. The default track priority for Backups is 1.
You enter the track priority as a parameter with the owner or backup command. Refer to “Track
port” on page 1118.
Syntax: owner [track-priority <value> ]
Syntax: backup [priority <value> ] [track-priority <value> ]
The syntax is the same for VRRP and VRRPE.
Backup preempt
By default, a Backup that has a higher priority than another Backup that has become the Master
can preempt the Master, and take over the role of Master. If you want to prevent this behavior,
disable preemption.
Preemption applies only to Backups and takes effect only when the Master has failed and a
Backup has assumed ownership of the VRID. The feature prevents a Backup with a higher priority
from taking over as Master from another Backup that has a lower priority but has already become
the Master of the VRID.
Preemption is especially useful for preventing flapping in situations where there are multiple
Backups and a Backup with a lower priority than another Backup has assumed ownership, because
the Backup with the higher priority was unavailable when ownership changed.
If you enable the non-preempt mode (thus disabling the preemption feature) on all the Backups,
the Backup that becomes the Master following the disappearance of the Master continues to be
the Master. The new Master is not preempted.
NOTE
In VRRP, regardless of the setting for the preempt parameter, the Owner always becomes the Master
again when it comes back online.
To disable preemption on a Backup, enter commands such as the following.
Router1(config)#inter e 1/6
Router1(config-if-1/6)#ip vrrp vrid 1
Router1(config-if-1/6-vrid-1)#non-preempt-mode