Liftgate Window Replacement
Special Tools
• BO-24402-A Glass Sealant Remover (Cold Knife)
• BO-39032 Stationary Glass Removal Tool
• Use an adhesive that is approved by GM
For equivalent regional tools, refer to
Special Tools
Removal Procedure
Warning:
Refer to
Cracked Window Warning
.
Note: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted
surfaces and the interior trim.
1. Open the liftgate.
2. Remove the liftgate trim. Refer to
Liftgate Trim Finish Panel Replacement
.
3. Disconnect the electrical connectors from the liftgate window defogger bus bar.
4. Remove the rear window wiper arm. Refer to
Rear Window Wiper Arm Replacement
.
5. Remove the rear spoiler. Refer to
Rear End Spoiler Replacement
.
Warning:
Refer to
Defroster Outlet Warning
.
6. Cover the following parts to protect from broken glass:
• Upper dash pad
• Defroster outlets and A/C outlets
• Seats and carpeting
Note: Keep the cutting edge of the appropriate tool against the window. There are window locating pins, one in each upper
corner of the window. Use care Not to remove or cut them off when removing the window. If the window locator pins are cut,
it will be necessary to tape the window in place.
7. This will allow the auto-adhesive to be separated from the window.
• Leave a base of auto-adhesive on the pinchweld flange.
• The only suitable lubrication is clean water.
• Use BO-24402-A Glass Sealant Remover (Cold Knife) .
• BO-39032 Stationary Glass Removal Tool , or equivalent in order to remove the window.
Fixed and Movable Windows
BODY SYSTEMS
0-4
BACK TO CHAPTER INDEX
TO MODEL INDEX
CHEVROLET SONIC 2012 BODY REPAIR MANUAL
