Canon imageRUNNER ADVANCE C5255, Руководство по обслуживанию, Страница: 154 / 1443

2
2
2-116
2-116
Technology > External Auxiliary System > Controls > Power Supply Control
Technology > External Auxiliary System > Controls > Power Supply Control
● Power save function
Standby
Case
①
Control panel switch is turned off
or
time is elapsed
Control panel switch is turned on
In the case of Deep Sleep In the case of Deep Sleep
In the case of
Deep Sleep
Case
②
Job Job
Job
Send Job
Sleep Standby
Sleep1
DC Controller PCB OFF
Reader Controller PCB OFF
Sleep1
DC Controller PCB ON
Reader Controller PCB ON
Deep Sleep
Sleep mode
Condition 1: Service mode "SLEEP1SW" = "0", and not in limited functions mode.
Meet the conditions not to move to Deep Sleep.
Condition 2: Service mode "SLEEP1SW" = "1", and in limited functions mode.
Meet the conditions not to move to Deep Sleep.
Standby
The mode that the machine is running or is ready to start operation. All power is supplied in
this mode.
Sleep mode
Energy saving mode Depending on the active controller, it is classified into the following 4
modes:
Sleep Standby
The Control Panel is OFF.
Other power supply states are the same as those in the standby mode.
F-2-152
Sleep 1 (DC Controller PCB, Reader Controller PCB: OFF)
Power is not supplied to the DC Controller PCB and the Reader Controller PCB. (Power is
supplied to the Main Controller PCB 1 and 2.)
When the value of service mode > COPIER > OPTION >USER > SLEEP1SW is "0" and the
machine is not in limited functions mode, the machine moves to this mode.
Sleep 1 (DC Controller PCB, Reader Controller PCB: ON)
Fixing Heater is OFF, and the Control Panel is OFF.
Other power supply states are the same as those in the standby mode.
When the value of service mode > COPIER > OPTION >USER > SLEEP1SW is "1" and the
machine is in limited functions mode, the machine moves to this mode.
If a job is submitted while the machine is in Deep Sleep, the machine moves to this mode.
Deep Sleep
The state that only 3V on the All-night Power Supply PCB is supplied.
• When a print job is submitted: The machine moves to Sleep Standby mode/Sleep 1 mode
(DC Controller PCB, Reader Controller PCB: ON).
NOTE:
When [Sleep Mode Energy Use] is set to [Low] at the time of using NetSpot Device
Installer (NSDI), there is a condition that causes startup from sleep mode to fail.
Condition: No IP address is specified.
Example: When the IP address is "0.0.0.0" and DHCP is set to OFF, the above
condition is satisfied; therefore, the machine fails to start up from sleep mode even if
connection is attempted from the network.
Remedy: Specify a static IP or set DHCP to ON.