Canon imageRUNNER ADVANCE C5255, Руководство по обслуживанию, Страница: 1104 / 1443

9
9
9-34
9-34
Installation > Installation Procedure > Adjusting Image Position > Lead-edge Margin Adjustment (1st side)
Installation > Installation Procedure > Adjusting Image Position > Lead-edge Margin Adjustment (1st side)
5) Loosen the fixing screw for the Multi Purpose Tray Upper Cover.
Screw
6) Move the Multi Purpose Tray Upper Cover back and forth according to the value confirmed
in step 2). Moving the Multi Purpose Tray Upper Cover to the rear of this equipment
increases the left margin.
7) Tighten the fixing screw for the Multi Purpose Tray Upper Cover.
8) Place paper on the Multi Purpose Tray.
9) Make copy from the Multi Purpose Tray, and check that the left margin is 2.5 -/+ 1.5mm.
F-9-71
F-9-72
■ Margin Adjustment with Multi Purpose Tray (2nd side)
1) Make 2-sided copy from the manual feed tray, and check that the left margin on the 2nd
side is 2.5 -/+ 2.0mm.
2) If the left margin is out of the specification, change the adjustment value for the left margin
on the 2nd side from the Multi Purpose Tray.
Service Mode (Level 1) > COPIER > ADJUST > FEED-ADJ > ADJ-MFRE ; 1 increment of
the value reduces the left margin by 0.1mm.
3) To make the setting value effective, turn OFF/ON the main power of the Host Machine.
4) Write down the new adjustment value on the service label.
ADJ-MFRE
■
Lead-edge Margin Adjustment (1st side)
1) Make copy from cassettte 1, and check that the lead-edge margin is L1 = 4.0 +1.5/-1.0
mm. If the lead-edge margin is out of the specification, go through the following steps to
make adjustment.
Feeding direction
of paper
image
L1
2) Select the following in Service Mode (Level 1) : COPIER > ADJUST > FEED-ADJ >
REGIST
3) Change the setting value to make adjustment (1 increment of the setting value reduces the
lead-edge margin by 0.1mm)
4) To make the setting value effective, turn OFF/ON the main power of the Host Machine.
5) Write down the new adjustment value on the service label.
• REGIST
F-9-73