Bosch Rexroth Tightening System 350, Руководство пользователя

Страница: 409 / 641

3 608 878 300 Tightening Technology | Bosch Rexroth AG 409 /641
System 350 | 3 608 878 300/2019-03
MID 0102
Acknowledge application results data
1)
MID 0103
Cancel application results data
1))
Spindle status Status of each individual spindle:
– Byte 1-2: Consecutive number of the tightening position in the
application (value range: 01-10)
– Byte 3-4: Channel ID (value range: 01-40)
– Byte 5: Tightening status (value range: 0: NOK, 1: OK)
– Byte 6: Torque status (value range: 0: Low, 1: OK, 2: High). At spindle
bypass (bypass), the value 0 is entered.
– Byte 7-12: Torque result multiplied by 100 as whole number
(decimals are cut off; value range: 000000-999999)
– Byte 13: Angle status (value range: 0: Low, 1: OK, 2: High)
At spindle bypass (bypass), the value 0 is entered.
– Byte 14-18: Angle of turn (value range: 00000-99999)
The information content of each spindle consists of 18 ASCII characters.
ID 18
2
Value range 000000000000000000 –
999999999999999999
Presetting -
Example:
Spindle status 010200002400000240
Value 010200002400000240
18 x
number
of
spindles
Data length revision 001
154 + 18
x number
of
spindles
Table 6–110: MID 0101 revision 001
Parameter Comments Bytes
1) This message is supported from version V2.300 of the Rexroth Tightening System 350 .
Sent by:
superordinate computer
Acknowledge application results data
Note:
-
Revision:
001 (Rexroth OP-Ford)
Data field:
is empty, 0 bytes
Possible response:
none
Sent by:
superordinate computer
Reset the subscription for application result.
Note:
-
Revision:
001 (Rexroth OP-Ford)
Data field:
is empty, 0 bytes
Possible responses MID Error no. Comment
Command accepted 0005 –
Command error 0004 34 Activation for multiple spindle results not available