Bosch Rexroth Tightening System 350, Руководство пользователя

Страница: 322 / 641

322 /641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
6.5.3 Chronological sequence of the tightening result data output process
6.5.3.1 Results output in an application
(4) Due to the hardware buffering in the data interfaces, parts of the printer protocol may be output only
after process end (FO x CyCmp). For complete data transfer, you must wait for the protocol end ("ETX"
end trigger character 0x03).
Here, the actual tightening end of the tightening application (tightening and process communication unit
completed) is indicated by the evaluation signals (FO x Ok, FO x Nok) switching from L to H as well. At
this point, the tightening spindles can be removed from the processed component.
The transfer is started once the results have been processed. After the results have been transferred
successfully, the tightening cycle is ended (control signal FO x CyCmp).
Additional chronological sequences can be found in chapter 5 , Control signals , from page 121 . In this
chapter you can find several examples for clarification of result output on a printer.
(A) Tightening application
(B) Output on printer
FO x Cw Start
FO x InCy Start active
FO x CyCmp Process end
FO x Ok Evaluation
(1) Tightening application cycle
(2) Sequence
(3) Result processing
(4) See explanation below