43
Any user can be allowed to turn an Output ON. This Function can be used to control external devices via the panel
keypad with a User assigned to that Output. Once an Output is turned ON by a User, the Output can turn OFF again
automatically if a reset time is assigned to the Output, or it can be turned off by the same user or by a different user
with the next program location.
USER can turn an OUTPUT OFF
USER can turn an OUTPUT OFF
- P14E 1-100E
Option 1 - User can turn OFF Output # 1
Option 2 - User can turn OFF Output # 2
Option 3 - User can turn OFF Output # 3
Option 4 - User can turn OFF Output # 4
Option 5 - User can turn OFF Output # 5
Option 6 - User can turn OFF Output # 6
Option 7 - User can turn OFF Output # 7
Option 8 - User can turn OFF Output # 8
Any user can be allowed to turn an Output OFF. This Function can be used to control external devices via the panel
keypad with a User assigned to that Output. Once an Output is turned OFF by a User, the Output can be turned on by
the same user or by a different user with the previous program location.
RADIO PENDANT PANIC ALARM to OUTPUT
RADIO PENDANT PANIC ALARM to OUTPUT
- P15E 21-100E (NOTE: only Users 21-100 can be Radio Users)
Option 1 - A Pendant Panic Alarm will Operate Output # 1
Option 2 - A Pendant Panic Alarm will Operate Output # 2
Option 3 - A Pendant Panic Alarm will Operate Output # 3
Option 4 - A Pendant Panic Alarm will Operate Output # 4
Option 5 - A Pendant Panic Alarm will Operate Output # 5
Option 6 - A Pendant Panic Alarm will Operate Output # 6
Option 7 - A Pendant Panic Alarm will Operate Output # 7
Option 8 - A Pendant Panic Alarm will Operate Output # 8
If a Radio Pendant is programmed to create a Panic Alarm (see P8E), when the Panic Alarm is activated it can be silent
or it can turn on an Output. This option would normally be used to turn on any internal and/or external audible
alarms connected to Outputs during a Pendant Panic Alarm.
LEARN RADIO PENDANT CODES
LEARN RADIO PENDANT CODES
- P18E 21-100E (NOTE: only Users 21-100 can be Radio Pendants)
A Radio Pendant must be enrolled into the panel before it can be used.
To learn a Radio Pendant you must first have a compatible receiver connected to the panel keypad buss. With the
receiver connected and the panel in program mode, entering P18E then the pendant number you wish to enrol, eg
21E for pendant 21, the keypad will start to beep to indicate that learn mode has been started and the LED on the
receiver will flash. Now operate the pendant you wish to learn into User slot 21. Once the transmitted code has been
received by the panel and saved as pendant 21, the keypad will stop beeping and the LED on the receiver will stop
flashing. When learning a new radio code the panel checks all possible locations (including radio zones) before saving
the new code to ensure that the code has not already been loaded into another slot. If the code already exists, the
keypad will indicate which slot the code is already installed at. A number from 1-16 indicates a zone slot and a
number from 21-100 indicates a user slot.
DELETE a RADIO PENDANT CODE
DELETE a RADIO PENDANT CODE
- P19E 21-100E (NOTE: only Users 21-100 can be Radio Pendants)
If you wish to delete a single Radio Pendant, pressing P19E then the Pendant User number while in Program Mode will
delete the stored code against that User, eg P19E 21E will remove the code stored for User 21.
