38
USER PROGRAMMING
USER CODES
- P1E 1-100E (NOTE: Users 21-100 can be Radio Users)
Adding or changing a User Code
Up to 100 codes can be programmed into the panel. The user codes are located in address P1E 1-100E.
By default, Code 1 has Master Code permissions and must be used to enter Client program mode.
Codes 1-100 may be varied in length from 1 to 6 digits (unless option 8 at P25E11E is on then the codes must be
between 4-6 digits long).
To program a User Code you must first be in client or installer program mode, then select the address P1E followed
by the User Number you wish to program eg 1-100E (If there is already a code programmed at this address, it will be
displayed back to you) Now enter the code then press the <
ENTER>
key.
eg. P1E2E 2580 E
3 beeps - program light on solid or flashing
In this example we have programmed Code 2 to be 2580.
eg. P1E5E 9876 E
3 beeps - program light on solid or flashing
In this example we have programmed code 5 to be 9876
To replace a code simply enter the new code in the same address as the old code. This will overwrite the previous
code but maintain the user permissions as mapped to that user number.
NOTE: When displaying User Codes on an LED keypad, digits 1-9 use the zone indicators 1-9. The digit 0 is indicated
by the "AUX” light.
Removing a User Code
To remove or delete a code simply press the <BYPASS> button after entering the code address when using an LED
keypad, or press and hold the <CONTROL> button then within 2 seconds press the <0> button if using an LCD
keypad.
eg. LED Keypad press P1E3E <
BYPASS>
E
3 beeps - Program light on solid or flashing
User Code # 3 Erased
eg. LCD Keypad press P1E3E <
CONTROL>
then <0>
3 beeps
User Code # 3 Erased
USER CODE TYPE
USER CODE TYPE
- P2E 1-100E (NOTE: only Users 21-100 can be Radio Users)
Option 0 - Keypad Code User {PIN}
Option 1 - Radio user (User 21-100 only)
Option 2 - Access Tag/Card User
Option 3 - Both Code and Access Tag/Card User {Tag + PIN}
Option 4 - Either Code or Access Tag/Card User {Tag or PIN}
Option 0
Keypad
Code User {PIN}
- All 100 Users can be 1-6 digit code Users if required. Codes can be used to
Arm/Disarm all or part of the alarm or they can be used to operate outputs for access control purposes.
Users can be assigned to keypads and so can outputs so that a User assigned to multiple outputs
(which can in turn be linked to doors) can operate only the door assigned to the keypad they are using.
Note: Where there are up to 8 options at one address, the digits 0 & 9 have special functions. Entering
a 0 at the address will turn all options off whereas entering a 9 will turn all options on.
