27
NOTE: If the last saved version of text for Zone 1 was in fact the default setting, then pressing “Control” then “1” or “A” will
return the default text anyway.
RESETTING ALL TEXT TO DEFAULT
While in “Local Edit Mode” it is possible to restore all of the customisable text fields to the factory default settings.
When you enter in
[PROG]-[801]-[ENTER]
display will prompt you to press
[801]-[ENTER]
again. Once you have pressed
“801 enter”, all customisable text (eg zone names, user names, output names, etc) will be returned to the default text.
COPYING TEXT TO ANOTHER LCD KEYPAD
If more than one LCD keypad is connected to the panel, it is possible to copy the edited Text from one LCD keypad to all
other LCD keypads connected to the same panel.
When you enter in
[PROG]-[800]-[ENTER],
all of the customisable text at the keypad will be transferred to all other LCD
keypads connected to the control panel.
To maintain compatibility with earlier LCD keypads there is also an alternative method to transfer the text. If using an
Portrait Keypad, while in “Local Edit Mode” at the keypad with the edited text press
“Control
” followed within 2 seconds
by
“3”
.
If using a Landscape Keypad pressing the
“CHIME”
button for 2 seconds while in “Local Edit Mode” will perform
the transfer. The text in your keypad will be transferred to all other LCD keypads connected to the panel.
EXITING LOCAL EDIT PROGRAM MODE
Press and hold the <PROGRAM> button for 2 seconds and the LCD keypad will leave Local Edit Mode and return to Idle
Mode or;
Press the <PROGRAM> button repeatedly until the display reads “Exit Programming”, then press the <ENTER>
button to exit program mode.
