ZF Marine ClearCommand 9000 Series, Installation, Operation And Troubleshooting Manual

Page: 85 / 272

SET UP
Page5-9
5-6.1.2 Function Code
A1
– Number of Engines
5-6.1.3 Function Code
A2
– One Lever Operation
In Twin Screw or more applications, the System has the
ability to command all engines and transmissions to the
same speed and direction with a single Control Head lever.
This Function allows this Feature to be enabled or disabled.
(Refer to Section 2-9, page 2-5,, for operation instructions)
The available Values for this Function are:
00 Disabled (Default Value)
01 Enabled
Figure 5-11: Display LED
Function A0 Set Up Activated
To change the Value (Refer to Sections
5-2 and 5-3, page 5-5
):
A) Scroll to Function Code
A0
.
B) Activate Set Up Mode.
C) Scroll Up or Down to the desired Value.
D) Store the Value to memory.
The total number of engines must be entered into the mem-
ory of each of the Processors. All Processors in an installa-
tion must have the same value entered.
The available Values for this Function are:
01 Single Screw (Default Value)
02 Twin Screw
03 Triple Screw
04 Quad Screw
05 Quint Screw
NOTE: T
WIN SCREW OR MORE APPLICATIONS REQUIRE
F
UNCTION
C
ODE
A1 V
ALUES CHANGED ON ALL
P
ROCESSORS PRIOR TO CHANGING THE
V
ALUE OF
F
UNCTION
C
ODE
A0.
Figure 5-12: Display LED Function
A1 Set Up Activated
To change the Value (Refer to Sections
5-2 and 5-3, page 5-5
):
A) Scroll to Function Code A1.
B) Activate Set Up Mode.
C) Scroll Up or Down to the desired Value.
D)
Store the Value to memory.
NOTE: B
EFORE CONTINUING SET UP
,
WAIT
5
MINUTES OR CYCLE POWER
.
Figure 5-13: Display LED
Function A2 Set Up Activated
To change the Value (Refer to Sections
5-2 and 5-3, page 5-5
):
A) Scroll to Function Code
A2
.
B) Activate Set Up Mode.
C) Scroll Up or Down to the desired Value.
D) Store the Value to memory.
Function Code is Blinking