ZF Marine ClearCommand 9000 Series, Installation, Operation And Troubleshooting Manual

Page: 102 / 272

SET UP
Page5-26
5-6.5.2.4 Function Code L6 – Troll Pulse Percentage
This Function Code selects the percentage of avail-
able Troll Servo Range the Processor’s push-pull
cable travels when first engaging the Clutch while in
Troll.
The available Values for this Function are
01.0
% to
100.0
%
The default Value is
90.0
%.
To determine, and if required, change the Value
(Refer to Sections 5-2 and 5-3, page 5-5):
5-6.5.3 9001 Troll Actuator Functions (Servo 3)
Refer to the manual supplied with the 9001 Troll Actuator
for the Set Up Procedures for Trolling.
5-6.5.4 Integrated Troll Solenoid Functions
This section along with Section 5-6.4.1 Basic Troll Com-
mand Functions allows the adjustment of Integrated Troll
Solenoid related items:
5-6.5.4.1 Function Code L1 – Troll Valve Function
This Function Code presets the profile and the
amount of current delivered to the Trolling Valve’s
proportional solenoid.
The Values for this Function are listed below:
00
- Normal, No Current when at Lock-up
01
- Inverse, No Current when at Lock-up
02
- Normal, Maximum Current when at Lock-up.
Preset for ZF220-550, 12VDC Systems.
NOTE: D
O NOT MAKE ANY ADJUSTMENTS TO
F
UNCTION
C
ODES
L5
AND
L6
UNTIL THE VESSEL HAS BEEN
SEA
-
TRIALED AND
F
UNCTION
C
ODES
L0, L1, L2, L3,
AND
L4
HAVE BEEN PROPERLY ADJUSTED
.
F
OR
I
NTEGRATED
T
ROLL DETAILED INSTRUCTIONS ON THE ADJUSTMENT OF
L5
CAN BE FOUND IN
S
ECTION
5-6.4.1.6
PAGE
5-33. T
HE ADJUSTMENT OF
I
NTEGRATED
S
ERVO
T
ROLL
L6
CAN BE
FOUND IN THE FOLLOWING
S
ECTION
5-6.5.2.4, F
UNCTION
C
ODE
L6 – T
ROLL
P
ULSE
P
ERCENT
-
AGE
.
Figure 5-53: Display LED
Function L6 Set Up Activated
To determine, and if required, change the Value
(Refer to Sections 5-2 and 5-3, page 5-5):
A)With Troll selected, place the Control Head
lever into the Ahead detent.
• If the vessel lunges forward or the shaft takes
too long to start rotating, continue with the next
step.
B) Scroll to Function Code
L6
.
C) Activate Set Up Mode.
D) Scroll Up or Down to the desired Value
E) Store the Value to memory
NOTE: A
LL
T
ROLL
F
UNCTIONS OTHER THAN
L0
WILL NOT BE DISPLAYED ON THE
P
ROCESSOR
D
ISPLAY
LED
IF
F
UNCTION
L0
IS SET TO
00. T
O UTILIZE
T
ROLL AND DISPLAY THE REST OF THE
T
ROLL
F
UNCTIONS
,
A VALUE OTHER THAN
00
NEEDS TO BE ENTERED FOR
F
UNCTION
L0.