ZF Marine ClearCommand 9000 Series, Installation, Operation And Troubleshooting Manual

Page: 66 / 272

INSTALLATION
Page4-11
be routed to PB2 on the Circuit Board as shown
in
Figure 4-11:
,
page 4-14
.
C) Strip back 2 inches (50,8mm) of the PVC jacket-
ing. Refer to Figure 4-15:
D) Strip each wire 3/8-inch (9,5mm).
E) Place a 3/8 inch (9,5mm) section of shrink tubing
over the cable and heat.
F) Crimp fork or ring terminals to the wires.
G) Connect the two-conductor cable to PB2, red lead
to the terminal labeled (1) and yellow lead to the
terminal labeled (2), as indicated on
Figure 4-6:
,
page 4-11
.
H) Tie wrap the start interlock cable to the Proces-
sor’s frame.
4-4.6.3 Power Cable (Location 5)
A) Run the length of two-conductor power cable between
the DC Power Source and the Processor.
B) Make the connections at the vessel’s DC Power Source,
but do not turn power ON.
C) Install a liquid tight connector into the DC POWER
entry hole (No. 5). (Refer to Figure 4-5:, page 4-10, for
entry hole location and Figure 4-4:, page 4-10, for cable
grip installation.)
D) Run enough of the two-conductor power cable through
the liquid tight cable grip so that it can be routed as
shown in Figure 4-6:, page 4-11.
E) Strip back 3 inches (76,2mm) of the PVC jacketing.
Refer to Figure 4-16:
F) Strip each wire 3/8-inch (9,5mm).
G) Place a 3/8 inch (9,5mm) section of shrink tubing over
the cable and heat.
H) Crimp fork or ring terminals to the wires.
Figure 4-15: Two-Conductor Start Interlock Cable
Figure 4-16: Two-Conductor Power Cable
3/8 inch
(9,5mm)
3 inches
(76,2mm)
Heat Shrink