ZF Marine ClearCommand 9000 Series, Installation, Operation And Troubleshooting Manual

Page: 40 / 272

OPERATION
Page 2-15
2-13.1.6 Five Seconds On, Five Seconds Off - High Repetitive Rate
Tone
Detail information on this tone is in Appendix B.
This tone indicates that Function Code
A3
Station
Expander (SE) has had the value
01
Enabled entered, but
the Processor and Station Expander cannot communicate.
2-13.2 Throttle (Servo 2) Tones
The following Tones are in addition to the Basic Tones listed in
Section 2-12.1, page 2-40.
2-13.2.1 One Long - Two Short Tones
Detail information on this tone is in Section B5-3.1,
page B5-7.
This tone indicates that the feedback potentiometer signal
from Servo 2 (Throttle) has gone out of range.
2-13.2.2 One Long, Two Short - High Repetitive Tone
Detail information on this tone is in Section B5-3.2,
page B5-8.
This tone indicates that Servo 2 (Throttle) cannot reach the
commanded position. This tone is also referred to as Servo
2 Jam Tone.
2-13.3 Clutch (Servo 1) Tones
The following Tones are in addition to the Basic Tones listed in
Section 5-6.3.1, page 5-21
2-13.3.1 One Long - One Short Tone
Detail information on this tone is in Section B5-2.1,
page B5-6.
This tone indicates that the feedback potentiometer signal
from Servo 1 (Clutch) has gone out of range.
2-13.3.2 One Long, One Short -High Repetitive RateTone
Detail information on this tone is in Section B5-2.2,
page B5-6.
This tone indicates that Servo 1 (Clutch) cannot reach the
commanded position. This tone is also referred to as Servo
1 Jam Tone.
Figure 2-19: Five Seconds On, Five Seconds Off - High Repetitive Tone
Figure 2-20: One Long - Two Short Tones
Figure 2-21: One Long - Two Short - High Repetitive Tones
Figure 2-22: One Long - One Short Tone
Figure 2-23: One Long, One Short - High Repetitive Rate Tone