ZF Marine ClearCommand 9000 Series, Installation, Operation And Troubleshooting Manual

Page: 225 / 272

TROUBLESHOOTING
PageB12-2
Table B12-3: Power, Start Interlock, Pressure Switch, and Alarm Harness Pin-Out
PROCESSOR ENGINE and BATTERY
Figure B12-3: Power, Start Interlock,
Pressure Switch, Alarm Harness Pin
Out
Termination A Conductor Color Termination B Description
Pin 1 Yellow w/ Red
Trace
Starter Sole-
noid
Closed contact when In-com-
mand and at Neutral.
Pin 2 Red External
Alarm Cir-
cuit
Normally Open contact
opens with fault or loss of
power.
Pin 3 Black External
Alarm Cir-
cuit
Normally Open contact
opens with fault or loss of
power.
Pin 6 Light Blue Clutch Pres-
sure Switch
Normally Open contact that
closes when transmission
manufacturer’s minimum
safe operating pressure is
reached.
Pin 7 Light Blue Clutch Pres-
sure Switch
Normally Open contact that closes when transmission manufacturer’s
minimum safe operating pressure is reached.
Pin 10 Red Battery (+) +12 or 24VDC.
Pin 11 Black Battery (-) - DC Return
Pin 12 Yellow w/ Red
Trace
Starter
Switch Wire
at the Starter
Solenoid
Closed contact when In-command and at Neutral.
Table B12-4: Serial Communication Harness Pin-Out
PROCESSOR PROCESSOR
Figure B12-4: Serial Communication
Harness Pin Out
Termination A Conductor Color Termination B Description
Pin 1 Black Pin 1 CAN Low
Pin 2 Red Pin 2 CAN High
Pin 6 Yellow/ Green N/C Shield
Table B12-5: Control Head Harness Pin-Out and Hard-Wire
PROCESSOR
PIGTAIL
(14261-X)
Figure B12-5: Control Head
Harness Plug Pin Out
Termination A Conductor Color Termination B Description
Pin 1 Green/ Yellow Pin 1 Shield
Pin 2 Brown Pin 2 Red LED (+)
Pin 3 Violet Pin 3 Green LED (-)
Pin 4 Orange Pin 4 Transfer Button (+)
Pin 5 Red Pin 5 Ground
Pin 6 Green Pin 6 Lever Command Signal
Pin 7 Blue Pin 7 VREF (+5VDC)
Pin 8 Black Pin 8 Tone (+)