185
Description
Technical requirements
Recommended equipment,
accessories and tools
Wheel ar-
rangement
4
х
4
6
х
6
Brake system
Check air drive tightness,
in doing so pay attention to
the friction surfaces or harm-
ful contacts of pipelines and
eliminate the troubles
Air system should have
no air leaks
+
+
Check outlet pressure out
of both brake valve sections
and operability of four-circuit
safety valve (see subsection
«Air Drive of Service Brake
System»)
Air pressure on the
test-pressure gages should
be equal to the pressure in
the system (see readings of
two-pointer pressure gage)
when the brake pedal is
fully depressed
Test-pressure gages
+
+
Check the brake pedal free
travel and adjust, if required
(see subsection «Air Drive of
Service Brakes»)
Brake pedal free travel
should be equal to 20-30
mm.
Wrenches
17x19,
22x24, screwdriver, pliers
+
+
Electric Equipment
Check density and level
of electrolytic solution in the
storage batteries, add distilled
water, if required
See the service manual
for the storage batteries
Wrenches
11x13,
17x19, vessel with distilled
water, glass pipe 3-5 mm
in diameter
+
+
Check fastening, cleanness
of and contact security of ca-
ble terminals to starter termi-
nals and of storage battery
Cable terminals fas-
tening should be safe
Wrenches
14x17,
17x19
+
+
Check and adjust head-
lamps, if required (see sub-
section «Lighting and Sig-
naling System»)
Adjust headlamps on
the unloaded truck placed
on an even horizontal
ground
Screwdriver,
screen
with special marks
+
+
Make sure the electricity
cable bundles are securely
fastened
Fastening should be
tight
Pliers,
screwdriver,
knife, insulating tape
+
+
Check the fastening of the
storage battery box brackets
to the frame
Ditto
Wrenches
17x19,
22x24
+
+
Clean battery surface from
the dust and dirt; clean vent
openings in the storage bat-
tery vent plugs
Battery surface as well
as vent plug openings
should be clean
Wiping material, wire
Ø 2 mm
+
+
