182
Description
Technical requirements
Recommended equipment,
accessories and tools
Wheel ar-
rangement
4
х
4
6
х
6
In winter to prevent mois-
ture condensing in fuel tank
fill it up to the full volume
Filling station
+
+
Drain condensate out off
air reservoirs. In winter drain
condensate every time you
leave warm garage
When draining conden-
sate, check that air reser-
voirs are under pressure
+
+
Maintenance at the beginning of operation after the run of
1500 - 3000 km (50-100 hours of engine operation) (M-(1500-3000))
Engine and its systems
Maintenance of the power
unit and EDC is to be con-
ducted in compliance with
Operation Manual for power
unit
Check and if required
tighten all the fastening
points of the power unit, all
the connections of the air in-
take and exhaust system
Loosening is not admis-
sible
Wrenches 14x17, 17x19
+
+
Transmission
Check and if necessary ad-
just the free travel and full
travel of the diaphragm sin-
gle-disk clutch pedal (see the
section
«Clutch
release
drive»)
For 4
х
4 and 6
х
6 trucks:
Clutch pedal free stroke
should be within the range
from 5 up to 10mm, Full
travel should be from 185
up to 190 mm.
Wrenches 17x19,
14x17, pliers, ruler
+
+
Check the tightening of
and, if necessary, tighten
the nuts fastening:
- propeller shafts;
Loosening is not al-
lowed
Wrench 17
х
19, box
wrench 22
х
24
+
+
- level, upper and lower
caps of steering knuckles and
ball joints flanges
Ditto
Box wrench 24x27
+
+
