![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-1000/tigerswitch-1000_management-manual_1300422401.webp)
S
PANNING
T
REE
C
OMMANDS
4-179
forwarding should only be enabled for ports connected to a LAN
segment that is at the end of a bridged LAN or for an end-node
device.)
• This command is the same as
spanning-tree edge-port
, and is only
included for backward compatibility with earlier products. Note that
this command may be removed for future software versions.
Example
Related Commands
spanning-tree edge-port (4 -177)
spanning-tree link-type
This command configures the link type for Rapid Spanning Tree. Use the
no
form to restore the default.
Syntax
spanning-tree link-type
{
auto
|
point-to-point
|
shared
}
no spanning-tree link-type
•
auto
- Automatically derived from the duplex mode setting.
•
point-to-point
- Point-to-point link.
•
shared
- Shared medium.
Default Setting
auto
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Specify a point-to-point link if the interface can only be connected to
exactly one other bridge, or a shared link if it can be connected to two
or more bridges.
Console(config)#interface ethernet 1/5
Console(config-if)#Spanning-tree portfast
Console(config-if)#
Summary of Contents for TigerSwitch 1000
