![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-1000/tigerswitch-1000_management-manual_1300422186.webp)
C
ONFIGURING
THE
S
WITCH
3-138
Adding Static Members to VLANs
(VLAN Index)
Use the VLAN Static Table to configure port members for the selected
VLAN index. Assign ports as tagged if they are connected to 802.1Q
VLAN compliant devices, or untagged they are not connected to any
VLAN-aware devices. Or configure a port as forbidden to prevent the
switch from automatically adding it to a VLAN via the GVRP protocol.
Notes: 1.
You can also use the VLAN Static Membership by Port page
to configure VLAN groups based on the port index
(page 3-140). However, note that this configuration page can
only add ports to a VLAN as tagged members.
2.
VLAN 1 is the default untagged VLAN containing all ports on
the switch, and can only be modified by first reassigning the
default port VLAN ID as described under “Configuring
VLAN Behavior for Interfaces” on page 3-141.
Command Attributes
•
VLAN
– ID of configured VLAN (1-4094, no leading zeroes).
•
Name
– Name of the VLAN (1 to 32 characters).
•
Status
– Enables or disables the specified VLAN.
-
Enable
: VLAN is operational.
-
Disable
: VLAN is suspended; i.e., does not pass packets.
•
Port
– Port identifier.
•
Membership Type
– Select VLAN membership for each interface by
marking the appropriate radio button for a port or trunk:
-
Tagged
: Interface is a member of the VLAN. All packets
transmitted by the port will be tagged, that is, carry a tag and
therefore carry VLAN or CoS information.
Summary of Contents for TigerSwitch 1000
