![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-1000/tigerswitch-1000_management-manual_1300422311.webp)
F
LASH
/F
ILE
C
OMMANDS
4-89
Command Mode
Privileged Exec
Example
This example shows the information displayed by the
whichboot
command. See the table under the
dir
command for a description of the
file information displayed by this command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system
[
unit
:] {
boot-rom
|
config
|
opcode
}:
filename
The type of file or image to set as a default includes:
•
boot-rom
* - Boot ROM.
•
config
* - Configuration file.
•
opcode
* - Run-time operation code.
•
filename
- Name of the configuration file or image name.
•
unit
* - Stack unit. (Range: 1-8)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
Console#whichboot
file name file type startup size (byte)
-------------------------------- ----------------------- ------- -----------
Unit1:
diag_0060 Boot-Rom image Y 111360
run_0200 Operation Code Y 1083008
startup Config File Y 2710
Console#
Summary of Contents for TigerSwitch 1000
