C
OMMAND
L
INE
I
NTERFACE
4-144
Table 4-39 show interfaces switchport - display description
Field
Description
Broadcast threshold
Shows if broadcast storm suppression is enabled or
disabled; if enabled it also shows the threshold level
(page 4-138).
LACP status
Shows if Link Aggregation Control Protocol has been
enabled or disabled (page 4-151).
Ingress rate limit
Shows if rate limiting is enabled, and the current rate limit.
(page 4-147).
VLAN membership
mode
Indicates membership mode as Trunk or Hybrid
(page 4-187).
Ingress rule
Shows if ingress filtering is enabled or disabled
(page 4-189).
Note:
Ingress filtering is always enabled.
Acceptable frame
type
Shows if acceptable VLAN frames include all types or
tagged frames only (page 4-188).
Native VLAN
Indicates the default Port VLAN ID (page 4-190).
Priority for untagged
traffic
Indicates the default priority for untagged frames
(page 4-208).
GVRP status
Shows if GARP VLAN Registration Protocol is enabled or
disabled (page 4-205).
Allowed VLAN
Shows the VLANs this interface has joined, where “(u)”
indicates untagged and “(t)” indicates tagged (page 4-191).
Forbidden VLAN
Shows the VLANs this interface can not dynamically join
via GVRP (page 4-192).
Private VLAN mode Shows the private VLAN mode as host, promiscuous,or
none.
Private VLAN
host-association
Shows the secondary (or community) VLAN with which
this port is associated.
Private VLAN
mapping
Shows the primary VLAN mapping for a promiscuous
port.
Summary of Contents for TigerSwitch 1000
