C
OMMAND
L
INE
I
NTERFACE
4-222
ip igmp snooping version
This command configures the IGMP snooping version. Use the
no
form
to restore the default.
Syntax
ip igmp snooping version
{
1
|
2
}
no ip igmp snooping version
•
1
- IGMP Version 1
•
2
- IGMP Version 2
Default Setting
IGMP Version 2
Command Mode
Global Configuration
Command Usage
• All systems on the subnet must support the same version. If there are
legacy devices in your network that only support Version 1, you will
also have to configure this switch to use Version 1.
• Some commands are only enabled for IGMPv2, including
ip igmp
query-max-response-time
and
ip igmp query-timeout
.
Example
The following configures the switch to use IGMP Version 1:
show ip igmp snooping
This command shows the IGMP snooping configuration.
Default Setting
None
Command Mode
Privileged Exec
Console(config)#ip igmp snooping version 1
Console(config)#
Summary of Contents for TigerSwitch 1000
