![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-1000/tigerswitch-1000_management-manual_1300422373.webp)
L
INK
A
GGREGATION
C
OMMANDS
4-151
channel-group
This command adds a port to a trunk. Use the
no
form to remove a port
from a trunk.
Syntax
channel-group
channel-id
no channel-group
channel-id
- Trunk index (Range: 1-32)
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When configuring static trunks, the switches must comply with the
Cisco EtherChannel standard.
• Use
no channel-group
to
remove a port group from a trunk.
• Use
no interfaces port-channel
to remove a trunk from the switch.
Example
The following example creates trunk 1 and then adds port 11.
lacp
This command enables 802.3ad Link Aggregation Control Protocol
(LACP) for the current interface. Use the
no
form to disable it.
Syntax
[
no
]
lacp
Default Setting
Disabled
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#
Summary of Contents for TigerSwitch 1000
