SMC Networks TigerSwitch 1000, Management Manual

Page: 357 / 480

I
NTERFACE
C
OMMANDS
4-135
Example
The following example configures port 11 to use autonegotiation.
Related Commands
capabilities (4 -135)
speed-duplex (4 -133)
capabilities
This command advertises the port capabilities of a given interface during
autonegotiation. Use the
no form with parameters to remove an advertised
capability, or the no form without parameters to restore the default values.
Syntax
[ no ] capabilities { 1000full | 100full | 100half | 10full | 10half |
flowcontrol | symmetric }
• 1000full - Supports 1000 Mbps full-duplex operation
• 100full - Supports 100 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 10half - Supports 10 Mbps half-duplex operation
• flowcontrol - Supports flow control
• symmetric (Gigabit only) - When specified, the port transmits and
receives pause frames; when not specified, the port will
auto-negotiate to determine the sender and receiver for
asymmetric pause frames. (
The current switch ASIC only supports
symmetric pause frames. )
Default Setting
• 1000BASE-T: 10half, 10full, 100half, 100full, 1000full
• 1000BASE-SX/LX/LH: 1000full
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#