A
CCESS
C
ONTROL
L
IST
C
OMMANDS
4-119
ip access-group
This command binds a port to an IP ACL. Use the
no
form to remove the
port.
Syntax
[
no
]
ip access-group
acl_name
{
in
|
out
}
•
acl_name
– Name of the ACL. (Maximum length: 16 characters)
•
in
– Indicates that this list applies to ingress packets.
•
out
– Indicates that this list applies to egress packets.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• A port can only be bound to one ACL.
• If a port is already bound to an ACL and you bind it to a different
ACL, the switch will replace the old binding with the new one.
• You must configure a mask for an ACL rule before you can bind it to
a port.
Example
Related Commands
show ip access-list (4-118)
show ip access-group
This command shows the ports assigned to IP ACLs.
Command Mode
Privileged Exec
Console(config)#int eth 1/25
Console(config-if)#ip access-group standard david in
Console(config-if)#
Summary of Contents for TigerSwitch 1000
