I
NITIAL
C
ONFIGURATION
2-10
2. To remove an existing string, simply type “no snmp-server community
string
,” where “string” is the community access string to remove. Press
<Enter>.
Trap Receivers
You can also specify SNMP stations that are to receive traps from the
switch.
To configure a trap receiver, complete the following steps:
1. From the Privileged Exec level global configuration mode prompt,
type “snmp-server host
host-address
community-string
,” where
“host-address” is the IP address for the trap receiver and
“community-string” is the string associated with that host. Press
<Enter>.
2. In order to configure the switch to send SNMP notifications, you must
enter at least one snmp-server enable traps command. Type
“snmp-server enable traps
type
,” where “type” is either
authentication
or
link-up-down
. Press <Enter>.
Saving Configuration Settings
Configuration commands only modify the running configuration file and
are not saved when the switch is rebooted. To save all your configuration
changes in nonvolatile storage, you must copy the running configuration
file to the start-up configuration file using the “copy” command.
To save the current configuration settings, enter the following command:
Console(config)#snmp-server community admin rw
Console(config)#snmp-server community private
Console(config)#
Console(config)#snmp-server enable traps link-up-down
Console(config)#
Summary of Contents for TigerSwitch 1000
