![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-1000/tigerswitch-1000_management-manual_1300422331.webp)
A
UTHENTICATION
C
OMMANDS
4-109
Example
dot1x timeout tx-period
This command sets the time that the switch waits during an authentication
session before re-transmitting an EAP packet. Use the
no
form to reset to
the default value.
Syntax
dot1x timeout tx-period
seconds
no dot1x timeout tx-period
seconds -
The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Example
show dot1x
This command shows general port authentication related settings on the
switch or a specific interface.
Syntax
show dot1x
[
statistics
] [
interface
interface
]
•
statistics
- Displays dot1x status for each port.
• interface
•
ethernet
unit
/
port
-
unit
- Stack unit. (Range: 1-8)
-
port
- Port number. (Range: 1-24/48)
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout tx-period 300
Console(config-if)#
Summary of Contents for TigerSwitch 1000
