C
ONFIGURING
THE
S
WITCH
3-78
Configuration:
•
Name
– Interface label.
•
Port admin
– Shows if the interface is enabled or disabled (i.e., up or
down).
•
Speed-duplex
– Shows the current speed and duplex mode. (Auto, or
fixed choice)
•
Capabilities
– Specifies the capabilities to be advertised for a port
during auto-negotiation. (To access this item on the web, see
“Configuring Interface Connections” on page 3-48.) The following
capabilities are supported.
-
10half
- Supports 10 Mbps half-duplex operation
-
10full
- Supports 10 Mbps full-duplex operation
-
100half
- Supports 100 Mbps half-duplex operation
-
100full
- Supports 100 Mbps full-duplex operation
-
1000full
- Supports 1000 Mbps full-duplex operation
-
Sym
- Transmits and receives pause frames for flow control
-
FC
- Supports flow control
•
Broadcast storm
– Shows if broadcast storm control is enabled or
disabled.
•
Broadcast storm limit
– Shows the broadcast storm threshold.
(240 - 1488100 packets per second)
•
Flow control
– Shows if flow control is enabled or disabled.
•
LACP
– Shows if LACP is enabled or disabled.
•
Port Security
– Shows if port security is enabled or disabled.
•
Max MAC count
– Shows the maximum number of MAC address
that can be learned by a port. (0 - 1024 addresses)
•
Port security action
– Shows the response to take when a security
violation is detected. (shutdown, trap, trap-and-shutdown)
Summary of Contents for TigerSwitch 1000
