![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-1000/tigerswitch-1000_management-manual_1300422310.webp)
C
OMMAND
L
INE
I
NTERFACE
4-88
Command Usage
• If you enter the command
dir
without any parameters, the system
displays all files.
• A colon (:) is required after the specified unit number.
• File information is shown below:
Example
The following example shows how to display all file information.
whichboot
This command displays which files were booted when the system powered
up.
Syntax
whichboot
[
unit
]
unit
- Stack unit. (Range: 1-8)
Default Setting
None
Table 4-26 File Directory Information
Column Heading
Description
file name
The name of the file.
file type
File types: Boot-Rom, Operation Code, and Config
file.
startup
Shows if this file is used when the system is started.
size
The length of the file in bytes.
Console#dir
file name file type startup size (byte)
-------------------------------- -------------- ------- -----------
Unit1:
diag_0060 Boot-Rom image Y 111360
run_01642 Operation Code N 1074304
run_0200 Operation Code Y 1083008
Factory_Default_Config.cfg Config File N 2574
startup Config File Y 2710
-------------------------------------------------------------------
Total free space: 0
Console#
Summary of Contents for TigerSwitch 1000
