![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-1000/tigerswitch-1000_management-manual_1300422351.webp)
SNMP C
OMMANDS
4-129
Example
Related Commands
snmp-server enable traps (4-129)
snmp-server enable traps
This command enables this device to send Simple Network Management
Protocol traps (SNMP notifications). Use the
no
form to disable SNMP
notifications.
Syntax
[
no
]
snmp-server enable traps
[
authentication
|
link-up-down
]
•
authentication
- Keyword to issue authentication failure traps.
•
link-up-down
- Keyword to issue link-up or link-down traps.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an
snmp-server enable traps
command, no
notifications controlled by this command are sent. In order to
configure this device to send SNMP notifications, you must enter at
least one
snmp-server enable traps
command. If you enter the
command with no keywords, both authentication and link-up-down
notifications are enabled. If you enter the command with a keyword,
only the notification type related to that keyword is enabled.
• The
snmp-server enable traps
command is used in conjunction with
the
snmp-server host
command. Use the
snmp-server host
command to specify which host or hosts receive SNMP notifications.
In order to send notifications, you must configure at least one
snmp-server host
command.
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Summary of Contents for TigerSwitch 1000
