C
OMMAND
L
INE
I
NTERFACE
4-58
Default Setting
Flash: errors (level 3 - 0)
RAM: warnings (level 7 - 0)
Command Mode
Global Configuration
Command Usage
The message level specified for flash memory must be a higher priority
(i.e., numerically lower) than that specified for RAM.
Example
logging host
This command adds a syslog server host IP address that will receive
logging messages. Use the
no
form to remove a syslog server host.
Syntax
[
no
]
logging host
host_ip_address
host_ip_address
- The IP address of a syslog server.
Default Setting
None
Command Mode
Global Configuration
1
alerts
Immediate action needed
0
emergencies
System unusable
Console(config)#logging history ram 0
Console(config)#
Table 4-18 Logging Levels (Continued)
Level Severity Name Description
* There are only Level 2, 5 and 6 error messages for the current firmware release.
Summary of Contents for TigerSwitch 1000
