I
NTERFACE
C
OMMANDS
4-133
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
The following example adds a description to port 24.
speed-duplex
This command configures the speed and duplex mode of a given interface
when autonegotiation is disabled. Use the
no
form to restore the default.
Syntax
speed-duplex
{
1000full
|
100full
|
100half
|
10full
|
10half
}
no speed-duplex
•
1000full
- Forces 1000 Mbps full-duplex operation
•
100full
- Forces 100 Mbps full-duplex operation
•
100half
- Forces 100 Mbps half-duplex operation
•
10full
- Forces 10 Mbps full-duplex operation
•
10half
- Forces 10 Mbps half-duplex operation
Default Setting
• Auto-negotiation is enabled by default.
• When auto-negotiation is disabled, the default speed-duplex setting is
1000full for Gigabit Ethernet ports.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• To force operation to the speed and duplex mode specified in a
speed-duplex
command, use the
no negotiation
command to
disable auto-negotiation on the selected interface.
Console(config)#interface ethernet 1/24
Console(config-if)#description RD-SW#3
Console(config-if)#
Summary of Contents for TigerSwitch 1000
