L
INE
C
OMMANDS
4-13
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to
set communication parameters for the serial port or Telnet (i.e., a virtual
terminal).
Table 4-5 Line Command Syntax
Command
Function
Mode Page
line
Identifies a specific line for configuration and
starts the line configuration mode
GC
4-14
login
Enables password checking at login
LC
4-15
password
Specifies a password on a line
LC
4-16
timeout login
response
Sets the interval that the system waits for a
login attempt
LC
4-17
exec-timeout
Sets the interval that the command interpreter
waits until user input is detected
LC
4-18
password-thresh Sets the password intrusion threshold, which
limits the number of failed logon attempts
LC
4-19
silent-time
*
*
These commands only apply to the serial port.
Sets the amount of time the management
console is inaccessible after the number of
unsuccessful logon attempts exceeds the
threshold set by the
password-thresh
command
LC
4-20
databits
*
Sets the number of data bits per character that
are interpreted and generated by hardware
LC
4-20
parity
*
Defines the generation of a parity bit
LC
4-21
speed
*
Sets the terminal baud rate
LC
4-22
stopbits
*
Sets the number of the stop bits transmitted per
byte
LC
4-23
disconnect
Terminates a line connection
PE
4-23
show line
Displays a terminal line's parameters
NE,
PE
4-24
Summary of Contents for TigerSwitch 1000
