S
YSTEM
M
ANAGEMENT
C
OMMANDS
4-67
Command Mode
Global Configuration
Command Usage
You may use an symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
Example
This example will send email alerts for system errors from level 3 through 0.
logging sendmail destination-email
This command specifies the email recipients of alert messages. Use the
no
form to remove a recipient.
Syntax
[
no
]
logging sendmail destination-email
email-address
email-address
- The source email address used in alert messages.
(Range: 1-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you
must enter a separate command to specify each recipient.
Example
Console(config)#logging sendmail source-email [email protected]
Console(config)#
Console(config)#logging sendmail destination-email
Console(config)#
Summary of Contents for TigerSwitch 1000
