M
IRROR
P
ORT
C
OMMANDS
4-145
Mirror Port Commands
This section describes how to mirror traffic from a source port to a target
port.
port monitor
This command configures a mirror session. Use the
no
form to clear a
mirror session.
Syntax
port monitor
interface
[
rx
|
tx
|
both
]
no port monitor
interface
•
interface
-
ethernet
unit
/
port
(source port)
-
unit
- Stack unit. (Range: 1-8)
-
port
- Port number. (Range: 1-24/48)
•
rx
- Mirror received packets.
•
tx
- Mirror transmitted packets.
•
both
- Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is
for both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
Table 4-40 Mirror Port Commands
Command
Function
Mode Page
port monitor
Configures a mirror session
IC
4-145
show port monitor Shows the configuration for a mirror port
PE
4-146
Summary of Contents for TigerSwitch 1000
