C
OMMAND
L
INE
I
NTERFACE
4-228
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The switch must use IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds.
Related Commands
ip igmp snooping version (4 -222)
Static Multicast Routing Commands
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the
no
form to remove the configuration.
Syntax
[
no
]
ip igmp snooping vlan
vlan-id
mrouter
interface
•
vlan-id
- VLAN ID (Range: 1-4093)
•
interface
-
ethernet
unit
/
port
- unit - Stack unit. (Range: 1-8)
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Table 4-63 Static Multicast Routing Commands
Command
Function
Mode Page
ip igmp snooping vlan
mrouter
Adds a multicast router port
GC
4-228
show ip igmp snooping
mrouter
Shows multicast router ports
PE
4-229
Summary of Contents for TigerSwitch 1000
